Size 7 Tube Key Clamp Fitting - Offset Side Palm Fixing (A14)

Size 7 Tube Key Clamp Fitting - Offset Side Palm Fixing (A14)

The Offset Side Palm Fixing, also referred to as an A14 fitting, has been specifically designed to attach a vertical tube, within a guardrail or handrail structure, to a wall. It is commonly used to attach railings on elevated walkways. The fitting encompasses two fixing holes; the upper hole can be difficult to access and therefore, it is recommended that a threaded stud bolt is fixed to begin with. These threaded stud bolts should not protrude further than a maximum of 25mm from the guardrail structure. Additionally, you should consider the load requirements of the application as this fitting is not recommended for heavy loads and so, a Non-Structural Offset Side Palm Fixing (A16) can be used as an alternative.

Please Note: The Offset Side Palm Fixings are only compatible with M12 Through Bolts (ANC). However, these are specified as single products and will need to be purchased separately to the fitting.

The A14 fits a Size 7 Tube that has an outside diameter of 42.4mm.

Supplied in galvanised steel, the A14 key clamp fitting has an extra layer of protection against corrosion and weathering which can be caused by harsh weather conditions such as wind and rain, this means that very little to no maintenance is required after installation.

Please don’t hesitate to get in touch with our sales team on 01283 512 111 if you require any further information regarding the products within our Tube Clamp range.