Car Park Barriers
Car Park Barriers
The manual opening car park barriers are an ideal security solution for controlling and restricting access to your car park or business site.
These barriers are available in a range of widths from 2.0m up to 10.0m. Our single gate widths range from 2.0m- 6.0m and our double gate is 2.0m-10.0m. The leaves can be held open when the site is in use, and can be locked with the use of a heavy duty padlock (sold separately) to prevent access when the area is not in use.
Each barrier has been constructed from high quality galvanised steel, this zinc powder coating creates a protective barrier which helps to protect the metal against weathering and rust. This allows them to keep their silver finish for longer.
Available with either dig-in or bolt-down posts, these barrier systems can be installed in a wide variety of locations and ground types:
- Dig in posts: These have been designed to allow installation on softer ground types, where holes can be dug. This type of post is then held in place with the use of post mix (sold separately)
- Bolt down posts: This type of post can be used on harder ground surfaces, such as an area which has been covered in tarmac or concrete, where it may not be possible for time or cost reasons to dig holes. These are held in place with the use of ground anchor bolts (sold separately)
Powder Coating Available
For additional protection against the damaging effects of weathering and corrosion, our range of manual swing car park barriers are available to order with a polyester powder coating (PPC) in a range of RAL colours. These can be used to create an aesthetically pleasing entrance point to your site or can be used to seamlessly blend into existing perimeter fencing.
Contact us
Have any questions about our range of manual car park barriers, such as advice on installation or which would be best for your requirements? You can reach us by phone on 01283 512 111, by email at sales@firstfence.co.uk, or through our online chat service.