9.0m Pole Automatic Barrier
SKU: SPEC-BAR-0100
£2,668.00
EACH
£3,201.60 incl VAT
Images shown are for illustration purposes only and may differ slightly
Customise your Product
Select a Pedestal Reader
Choose your Access Control Equipment
Loop Detection
Loop Wire Required?
Specifications & Downloads
| Pole length | 9.0 Metres Plain Pole Only 8.0 Metres with Bottom Skirt 6.5 Metres with Hi-Bar |
| Dimensions | 454mm x 473mm x 1175mm |
| Boom Diameter | 115mm x 80mm Oval |
| Opening/ Closing Time | 4.0-9.0 Seconds (Adjustable) |
| Power Supply | Single Phase 230v 50Hz 4.0 Amps |
| Drive Unit | 3 Phase Motor & Wormed Gearbox |
| Finish | Aluminium & Polyester Powder Coated |
| Accessories | Pre-Wired Loop Detector Bases |
| Springs/ Counter Weights | NOT REQUIRED |
| Cycles | 100% Continuous Duty Cycle Rating |
| Control Panel | Programmable PCB & Inverter Driven |
| Safety Edge Controller | Direct Connection of Separate 8.2K? Safety Contact Edge |
| Ambient Humidity | -10 ~ 55 Degrees Centigrade |
| Fixings | M16 Anchor Shield Bolts Included |
| Control Panel IP Rating | IP57 |
| Settings | Programmable Configuration as Standard |
Product Description
9.0m Pole Automatic Barrier
Location & Function
This Heavy Duty Automatic Barrier has an arm length of 9.0m, providing automated and secure access to cars and HGVs entering your site. Provided with this barrier is a Control Panel which can be individually programmed to multiple factors, including adjustable rising arm speed.
Easy to install and with a low maintenance design, this barrier is ideal for a wide range of locations.
Motor and Operation
- This barrier has a 100% Continuous Duty Cycle through its Single Phase Supply, 3 Phase Motor and Two Stage Gear Box.
- The programmable Control Panel is Inverter Driven and comes with Fault Diagnostic on-screen display, with the Adjustable Speed, Acceleration and Deceleration for arm operation.
- A Manual Override is also included in case of power failure, as well as an 8.2K Safety Contact Edge. Ready for Loop Detectors to be installed, this barrier comes pre-wired for Single Channel Access Control.
- Due to the operation of this barrier, no springs or counterweights are needed, as it has Heavy Duty Roller Plunger Limit Switches.
Construction and Materials
- Aluminium Extruded Cabinet
- Removable Cast Aluminium Hood
- Heavy Duty Pillar Box Bearing
- Comes with M12 Anchor Shield Bolts for installation.
Access Control & Other Accessories
From the Access Control Guide below, this Barrier is compatible with the following accessories:
- GSM Intercom
- Proximity Access Keypads
- Reader Pedestals
- Loop Detectors & Loop Wires
Please don’t hesitate to contact us if you require any further information regarding our automatic barriers, you can get in touch by calling 01283 512 111 or by emailing sales@firstfence.co.uk.
This site, all original artwork and other media contained within is © 2021 First Fence Limited. All Rights Reserved.
‘First Fence‘ and the First Fence logo are trademarks of First Fence Limited.
A registered company in England and Wales No. 07142033, Vat No: GB 985368854