FF6000LUX - 7.0m Pole Automatic Barrier
This Automatic Barrier has an arm length of 7.0m and is a suitable automated access solution for both cars and HGVs.
*Please note all images are for illustration purposes only and actual products may vary.
Location & Function
This Automatic Barrier has an arm length of 7.0m and is a suitable automated access solution for both cars and HGVs. It offers a low maintenance design and is very easy to installation.
Included within this barrier is a Control Panel which can be individually programmed to multiple factors, to suit your access requirements.
Motor and Operation
- This barrier has a 100% Continuous Duty Cycle through its Single Phase Supply, 3 Phase Motor and Two Stage Gear Box.
- The programmable Control Panel is Inverter Driven and comes with Fault Diagnostic on-screen display, with the Adjustable Speed, Acceleration and Deceleration for arm operation.
- A Manual Override is also included in case of power failure, as well as an 8.2KΩ Safety Contact Edge. Ready for Loop Detectors to be installed, this barrier comes pre-wired for Single Channel Access Control.
- Due to the operation of this barrier, no springs or counterweights are needed, as it has Heavy Duty Roller Plunger Limit Switches.
Construction and Materials
- Aluminium Extruded Cabinet
- Removable Cast Aluminium Hood
- Heavy Duty Pillar Box Bearing
- Comes with M12 Anchor Shield Bolts for installation.
Access Control & Other Accessories
From the Access Control Guide below, this Barrier is compatible with the following accessories:
- GSM Intercom
- Proximity Access Keypads
- Reader Pedestals
- Loop Detectors & Loop Wires
|Pole length||4.0m Plain Pole|
|Opening/ Closing Time||1.5-4.0 Seconds (Adjustable)|
|Power Supply||Single Phase 230v 50Hz 4.0 Amps|
|Drive Unit||3 Phase Motor Wormed Gearbox|
|Finish||Aluminium Polyester Powder Coated|
|Accessories||Pre-Wired Loop Detector Bases|
|Springs/ Counter Weights||NOT REQUIRED|
|Cycles||100% Continuous Duty Cycle Rating|
|Control Panel||Programmable Inverter Driven|
|Boom Diameter||86mm x 60mm Oval|
|Safety Edge Controller||Direct Connection of Separate 8.2KΩ Safety Contact Edge|
|Dimensions||291mm x 354mm x 930mm|
|Ambient Humidity||-10 ~ 55 Degrees Centigrade|
|Fixings||M12 Anchor Shield Bolts Included|
|Control Panel IP Rating||IP57|
|Settings||Programmable Configuration as Standard|
Configure FF6000LUX - 7.0m Pole Automatic Barrier