FF6000HD - 9.0m Pole Automatic Barrier

£2,970.00 £3,564.00 Inc Vat

Easy to install and with a low maintenance design, this barrier is ideal for a wide range of locations.

Lead times may apply

*Please note all images are for illustration purposes only and actual products may vary.


Location & Function

This Heavy Duty Automatic Barrier has an arm length of 9.0m, providing automated and secure access to cars and HGVs entering your site. Provided with this barrier is a Control Panel which can be individually programmed to multiple factors, including adjustable rising arm speed.

Easy to install and with a low maintenance design, this barrier is ideal for a wide range of locations.


Motor and Operation

  • This barrier has a 100% Continuous Duty Cycle through its Single Phase Supply, 3 Phase Motor and Two Stage Gear Box. 
  • The programmable Control Panel is Inverter Driven and comes with Fault Diagnostic on-screen display, with the Adjustable Speed, Acceleration and Deceleration for arm operation. 
  • A Manual Override is also included in case of power failure, as well as an 8.2KΩ Safety Contact Edge. Ready for Loop Detectors to be installed, this barrier comes pre-wired for Single Channel Access Control. 
  • Due to the operation of this barrier, no springs or counterweights are needed, as it has Heavy Duty Roller Plunger Limit Switches.


Construction and Materials

  • Aluminium Extruded Cabinet
  • Removable Cast Aluminium Hood
  • Heavy Duty Pillar Box Bearing
  • Comes with M12 Anchor Shield Bolts for installation.


Access Control & Other Accessories

From the Access Control Guide below, this Barrier is compatible with the following accessories:

  • GSM Intercom 
  • Proximity Access Keypads  
  • Reader Pedestals
  • Loop Detectors & Loop Wires 

More Information
Pole length 9.0 Metres Plain Pole Only 8.0 Metres with Bottom Skirt 6.5 Metres with Hi-Bar
Opening/ Closing Time 4.0-9.0 Seconds (Adjustable)
Power Supply Single Phase 230v 50Hz 4.0 Amps
Drive Unit 3 Phase Motor & Wormed Gearbox
Finish Aluminium & Polyester Powder Coated
Accessories Pre-Wired Loop Detector Bases
Springs/ Counter Weights NOT REQUIRED
Cycles 100% Continuous Duty Cycle Rating
Control Panel Programmable PCB & Inverter Driven
Boom Diameter 115mm x 80mm Oval
Safety Edge Controller Direct Connection of Separate 8.2KΩ Safety Contact Edge
Dimensions 454mm x 473mm x 1175mm
Ambient Humidity -10 ~ 55 Degrees Centigrade
Fixings M16 Anchor Shield Bolts Included
Control Panel IP Rating IP57
Settings Programmable Configuration as Standard

No Related Posts

Copyright © 2013-2017 Magento, Inc. All rights reserved.